Transport; Storage - Kärcher K 5 Premium Mode D'emploi

Illustration
 Adjust the suction volume of the detergent solution
by means of the dosage regulator for detergents.
 Use spray lance with pressure regulation (Vario
Power).
 Turn the spray lance as far as it will go in the direc-
tion of "SOFT".
Note: This will mix the detergent with the water
stream.
Recommended cleaning method
 Spray the detergent sparingly on the dry surface
and allow it to react, but not to dry.
 Spray off loosened dirt with the high pressure jet.
Optional
Foam nozzle
 Fill the detergent solution in the detergent tank of
the foam nozzle (observe dosage instructions on
the packaging of the detergent).
 Connect the detergent tank to the foam nozzle.
 Connect the foam nozzle to the trigger gun.
Interrupting operation
 Release the lever on the trigger gun.
 Lock the lever on the trigger gun.
 Insert the trigger gun in its holder.
 During longer breaks (more than 5 minutes), also
turn the appliance off using the "0/OFF" switch.
Finish operation
CAUTION
Only separate the high-pressure hose from the trigger
gun or the appliance when there is no pressure in the
system.
ATTENTION
When disconnecting the supply or high pressure hose,
warm water may leak from the connections after opera-
tion.
 Remove the Plug 'n' Clean detergent bottle from
the intake and close it with the lid. To store, place
into the intake rotated by 180°.
 Release the lever on the trigger gun.
 Turn off the appliance "0/OFF".
 Disconnect the mains plug from the socket.
 Turn off tap.
 Press the lever on the trigger gun to release any re-
maining pressure in the system.
 Lock the lever on the trigger gun.
 Detach the appliance from the water supply.
14
CAUTION
Risk of personal injury or damage!
Mind the weight of the appliance during transport.
When transporting by hand
 Pull the appliance by its transport handle.
When transporting in vehicles
 Prior to horizontal transport: Remove the Plug 'n'
Clean detergent bottle from the intake and close it
with the lid.
 Secure the appliance against shifting and tipping
over.
CAUTION
Risk of personal injury or damage!
Consider the weight of the appliance when storing it.
Storing the Appliance
 Park the machine on an even surface.
 Press the disconnect on the trigger gun and re-
move the high pressure hose from the trigger gun.
 Insert the trigger gun in its holder.
 Engage the spray lance in its holder.
Illustration
 Roll the high pressure hose on to the hose drum:
Pull out the hose drum handle, turn it clockwise
then retract the handle.
 Stow the power cord and the remaining accesso-
ries on the appliance.
Prior to extended storage periods, as during the winter,
also observe the instructions in the Care section.
ATTENTION
Appliances and accessories that are not completely
drained can be destroyed by frost. Completely drain ap-
pliance and accessories and protect them against frost.
To avoid damage:
 Detach the appliance from the water supply.
 Detach spray lance from the trigger gun.
 Switch the appliance on ("I/ON"), press the trigger
gun lever until no further water is discharged (ap-
prox. 1 min).
 Turn off the appliance.
 Store the appliance and the entire accessories in a
frost free room.
– 8
EN

Transport

Storage

Frost protection