CASTLE HPS10IC Manuel De L'utilisateur page 5

CAUTION
ALL APPLICABLE BUILDING CODES FOR YOUR LO-
CATION MUST BE FOLLOWED. IN AREAS WHERE
BUILDING CODES REQUIRE ADDITIONAL STEPS
TO THE INSTALLATION OF THIS PRODUCT NOT IN-
CLUDED IN THIS MANUAL, THE BUILDING CODES
WILL TAKE PRECEDENT AND MUST BE FOLLOWED.
CONTACT YOUR LOCAL BUILDING INSPECTOR TO
OBTAIN ANY NECESSARY PERMITS OR INSPECTION
GUIDELINES BEFORE INSTALLING THE PRODUCT.
• Contact local building or fire officials about restric-
tions and installation inspection requirements in
your area.
• Contact your local authority (such as municipal
building department, fire department, fire preven-
tion bureau, etc.) to determine the need for a permit.
• The Castle Pellet Stoves pellet stove is designed to
burn pellet fuel only.
• A working smoke detector is required and must be
installed in the same room as the stove.
• This stove is not intended for use in commercial
applications.
• Door and ash pan must be closed and latched during
operation.
• Notify your insurance company of pellet stove instal-
lation.
• This installation must conform with local codes. In
the absence of local codes you must comply with
ASTM E1509, (UM) 84-hud, ulc/ordC-1482, and UCL
S627-2000.
• The structural integrity of the manufactured home
floor, wall, and ceiling/roof must be maintained.
• Keep combustible materials (such as grass, leaves,
etc.) at least three feet away from the flue outlet on
the outside of the building.
• This stove should not be used as the only source
of heat in the house. Power outages and periodic
maintenance will result in a total loss of heat.
• Do not leave hopper door open while unattended.
Check for parts online at www.castlestoves.com or call 800-345-6007 M-F 8-5 CST
CAUTION
INSTALLATION AND REPAIR OF THIS PELLET STOVE
SHOULD BE DONE BY A QUALIFIED SERVICE PERSON.
THE APPLIANCE SHOULD BE INSPECTED BEFORE USE
AND AT LEAST ONCE A YEAR BY A QUALIFIED SERVICE
PERSON. IT IS IMPERATIVE THAT THE CONTROL COM-
PARTMENTS, FIRE BOX, AND THE CIRCULATING AIR
PASSAGEWAYS OF THE STOVE BE KEPT CLEAN.
THE OPERATION OF EXHAUST FANS SUCH AS BATH-
ROOM FANS, ATTIC FANS, ETC. MIGHT STARVE THE
PELLET STOVE OF COMBUSTIBLE AIR CREATING A
NEGATIVE PRESSURE IN THE ROOM. PROVIDE ADE-
QUATE VENTILATION OF THE ROOM ACCOMPANYING
THE PELLET STOVE. IF NOT, THE PRESSURE SWITCH
MAY SHUT OFF OPERATION OF THE PELLET STOVE.
THE MOVING PARTS OF THIS STOVE ARE PROPELLED BY
HIGH TORQUE ELECTRIC MOTORS. THESE PARTS CAN
CAUSE SEVERE DAMAGE TO BODY PARTS THAT GET
NEAR THEM. KEEP ALL BODY PARTS AWAY FROM AU-
GER AND FANS WHILE THE STOVE IS PLUGGED INTO AN
ELECTRICAL OUTLET. THESE MOVING PARTS MAY BE-
GIN TO MOVE AT ANY TIME THE STOVE IS PLUGGED IN.
THE VENT SURFACES CAN GET HOT ENOUGH TO CAUSE
BURNS IF TOUCHED. NONCOMBUSTIBLE SHIELDING OR
GUARDS MAY BE REQUIRED.
INSTALL VENT AT CLEARANCES SPECIFIED BY THE
VENT MANUFACTURER.
ALL VENTING JOINTS, WHETHER VERTICAL OR HORI-
ZONTAL, SHOULD BE MADE GAS-TIGHT WITH REC-
OMMENDED SEALANTS SPECIFIED BY VENT MANU-
FACTURER.
ACCORDING TO HUD (HOUSING & URBAN DEVEL-
OPMENT) REQUIREMENTS, WHEN INSTALLED IN A
MOBILE HOME, THIS STOVE MUST BE GROUNDED
DIRECTLY TO THE STEEL CHASSIS OF THE MOBILE
HOME AND BOLTED TO THE FLOOR. DIRECT AIR AC-
CESS MUST BE PROVIDED, USE A FRESH AIR KIT.
FOR USE IN THE UNITED STATES AND CANADA. AP-
PROVED FOR INSTALLATION IN MOBILE HOMES.
CASTLE PELLET STOVES, PRODUCER OF THIS APPLI-
ANCE, RESERVES THE RIGHT TO ALTER ITS PRODUCTS,
SPECIFICATIONS AND/OR PRICE WITHOUT NOTICE.
Operator's Manual
HPS10IC Pellet Stove
5