Cleaning - Vollrath HPI4-2600 Manuel De L'opérateur

EDIT THE DEFAULT PROGRAMS (CONTINUED)
Transfer Programs to the Induction Range
1. Plug in the induction range. Do NOT turn on the range.
2. Only the Vollrath logo on the control panel should be illuminated.
3. Insert the USB flash drive into the induction range. The USB flash
drive can be left in the range for storage. Close the USB port cover.

CLEANING

To maintain the appearance and increase the service life, clean your
induction range daily.
WARNING
Electrical Shock Hazard
Do not spray water or cleaning products. Liquid could contact
the electrical components and cause a short circuit or an
electrical shock.
CAUTION
Burn Hazard
Heating surface remains hot after equipment is turned off. Hot
surfaces and food can burn skin. Allow the hot surfaces to cool
before handling.
NOTICE: Do not use abrasive materials, scratching cleansers or
scouring pads to clean the equipment. These can damage
the finish.
8 High Power Countertop Induction Ranges with Temperature Control Probe Operator's Manual
4. When the programs have transferred, the display will show
5. Press .
6. The new programs are now available for use.
1. Touch to turn off the range.
The display may show HOT until the cooking surface cools.
2. Unplug the cord from the wall outlet.
3. Allow the equipment to cool.
4. Wipe the exterior with a clean damp cloth.
5. Thoroughly wipe off any soap residue.
NOTICE: Residue could corrode the surface of the unit.
Clean the USB and Temperature Control Probe
Ports (As needed)
The USB and temperature control probe port covers should always be
in place when not in use to prevent food debris from entering the ports.
However, if food debris does enter the ports, they can be cleaned.
1. Turn off and unplug the induction range.
2. Use a cotton swab dipped into isopropyl alcohol to gently remove
the debris.
3. Allow the port(s) to air dry before placing the cap over the port(s).