Häfele DT 600 FH Notice De Montage page 6

4. Maintenance
instructions
5. EU Declaration
of conformity
6
NOTE
Risk of malfunctions due to key inside the profile cylinder
If the key has not been removed, there is risk of door terminal malfunctions.
> The key of the profile cylinder must always be removed.
> The profile cylinder is for emergency opening only.
In order to ensure that the equipment is usable in accordance with this document,
the following routine maintenance checks must be carried out at least once a month:
• Inspection and actuation of the panic exit device in order to ensure that all
components of the lock are in a satisfactory operating condition.
• The actuation force for releasing the panic exit device must be measured using a
dynamometer and recorded.
• It must be ensured that the locking counterpieces (striking plates) are not blocked
or clogged up.
• It must be checked whether the panic exit device has been greased in
accordance with the manufacturer's instructions.
• It must be checked that no additional locking devices have been attached to the
door.
• It must be checked at regular intervals whether all components of the system still
correspond with the list of permissible components that were originally delivered
with the system.
• Check regularly whether the operating device is correctly tigthened.
The actuation force for releasing the panic exit device must be measured using a
dynamometer. It must be checked whether the actuation force has undergone a
major change in comparison with the operating force recorded during the initial
installation.
Sphinx Electronics GmbH & Co KG hereby declares that the DT 600 /
600 FH electronic door fitting is compliant with directives 2014/53/EU
and 2011/65/EU. The complete text of the EU declaration of conformity
can be found under the product at the following web site:
www.haefele.de