Ferm JSM1022 Notice Originale page 8

Using the pendulum action switch (fig. A)
The pendulum action switch is used to set the
way in which the teeth of the saw blade grip the
material. The pendulum action switch can be set
to 4 positions.
2
Do not set the pendulum position during
use.
● Turn the pendulum action switch (4) to
required position according to the material to
be worked. Refer to the table below to select
the required position.
Material
Wood
Plastics
Aluminium
Steel
Ceramics
Rubber
Dust extraction (fig. E)
● Insert the dust extraction adapter (19) into the
dust extraction connection (10).
● Connect the hose of a vacuum cleaner to the
dust extraction adapter (19).
Hints for optimum use
● Clamp the workpiece. Use a clamping device
for small workpieces.
● Draw a line to define the direction in which to
guide the saw blade.
● Firmly hold the machine by the grip.
● Set the sawing speed.
● Set the mitre angle.
● Set the pendulum position.
● Switch on the machine.
● Wait until the machine has reached full speed.
● Place the saw shoe on the workpiece.
● Slowly move the machine along the pre-drawn
line, firmly pressing the saw shoe against the
workpiece.
● Do not apply too much pressure on the
machine. Let the machine do the work.
● Switch off the machine and wait for the
machine to come to a complete standstill
before putting the machine down.
8
CLEANING AND MAINTENANCE
4
● Regularly clean the housing with a soft cloth.
● Keep the ventilation slots free from dust and
● Regularly clean the saw blade to avoid
● Regularly lubricate the guide roller.
Replacing the saw blade (fig. B)
Pendulum position
Worn or damaged saw blades must be replaced
1-3
immediately.
2
1
0-1
0
0
● To remove the old saw blade (15), proceed as
0
● To mount the new saw blade (15), proceed as
WArrANTy
Consult the enclosed warranty terms.
ENVIrONMENT
Disposal
The product, the accessories, and the packaging
must be sorted for environmentally friendly
recycling.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/EU
for Waste Electrical and Electronic Equipment
and its implementation into national right, power
tools that are no longer usable must be collected
separately and disposed of in an environmentally
friendly way.
The product and the user manual are subject to
change. Specifications can be changed without
further notice.
Before cleaning and maintenance,
always switch off the machine and
remove the mains plug from the mains.
dirt. If necessary, use a soft, moist cloth to
remove dust and dirt from the ventilation slots.
inaccuracies during use.
Only use sharp and undamaged saw
blades.
described in the section „Mounting and
removing the saw blade".
described in the section „Mounting and
removing the saw blade".
Ferm