Ferm JSM1022 Notice Originale page 7

ASSEMBLy
4
Before assembly, always switch off the
machine and remove the mains plug
from the mains.
Mounting and removing the saw blade (fig. B)
Refer to the table below to select the required
saw blade.
Saw blade
Coarse
Medium
Fine
Very fine
2
Do not attempt to remove the guard from
the machine.
Mounting
● Raise the guard (5).
● Slacken the Allen screws (14) using the Allen
key (12).
● Insert the saw blade (15) in the saw blade
holder (6) as far as possible. The teeth of the
saw blade (15) must point upward and forward.
The smooth side of the saw blade must engage
in the slot of the guide roller (16).
● Tighten the Allen screws (14) using the Allen
key (12).
● Lower the guard (5).
removing
● Raise the guard (5).
● Slacken the Allen screws (14) using the Allen
key (12).
● Remove the saw blade (15) from the saw
blade holder (6).
● Tighten the Allen screws (14) using the Allen
key (12).
● Lower the guard (5).
Mounting and removing the parallel guide
(fig. C)
The parallel guide is used for sawing along edges
at a maximum distance of 16 cm.
Mounting
● Slacken the Allen screws (8) using the Allen
key (12).
● Insert the parallel guide (17) into the saw shoe
(7).
● Set the parallel guide (17) to the required
position.
Ferm
Material
Wood
Wood
Steel, aluminium, plastic
Wood (curves)
● Tighten the Allen screws (8) using the Allen
key (12).
removing
● Slacken the Allen screws (8) using the Allen
key (12).
● Remove the parallel guide (17) from the saw
shoe (7).
● Tighten the Allen screws (8) using the Allen
key (12).
USE
Switching on and off (fig. A)
● To switch on the machine, press the on/off
switch (1).
● To switch the machine to continuous mode,
keep the on/off switch (1) pressed and
simultaneously press the lock-on button (2).
● To switch off continuous mode, press the
on/off switch (1) again.
● To switch off the machine, release the on/off
switch (1).
Setting the speed (fig. A)
The speed adjustment wheel is used for setting
the speed. The speed adjustment wheel can be
set to 6 positions. The ideal speed depends on
the profile and the teeth of the saw blade and on
the material to be worked.
2
Do not set the speed during use.
● Turn the speed adjustment wheel (3) to the
required position.
- For hard materials, use a saw blade with
fine teeth and select a lower speed.
- For soft materials, use a saw blade with
coarse teeth and select a higher speed.
Setting the mitre angle (fig. D)
The mitre angle is variable between 0° and 45°.
The mitre angle can be read from the scale (9).
2
Do not set the mitre angle during use.
● Slacken the Allen screws (18) using the Allen
key (12).
● Tilt the saw shoe (7) to the required position.
● Tighten the Allen screws (18) using the Allen
key (12).
7