ResMed AirSense 10 Manuel De L'utilisateur page 5

3. Connect the oximeter adapter to your device.
4. Align the Xpod oximeter connector with the oximeter adapter port and
connect them.
Not pictured:
5. Connect the Xpod oximeter to the finger pulse sensor.
For instructions refer to the User Guide supplied with the finger pulse sensor.
6. Connect the finger pulse sensor to your finger.
7 . Plug your device back into the power outlet.
The AirSense 10 / AirCurve 10 / Lumis device will briefly display the oximeter
software code, eg, SX123-4567 .
The S9 device will briefly display Oximeter enabled.
You are now ready to start therapy. For more information, refer to your device
User Guide.
Removing and returning the oximeter adapter and
SD card
1. Remove the sensor from your finger.
2. Unplug your device from the power outlet.
3. Press the release button/s on the side of the oximeter adapter and pull gently
to remove it from the device.
4. Pull the Xpod oximeter out of the oximeter port on the oximeter adapter.
5. Remove the finger sensor cable from the Xpod oximeter.
6. Open the SD card cover and push in the SD card to release it.
7 . Place the SD card in the protective folder and send it back to your care provider
together with the oximeter adapter and this User Guide.
English 3