Thermador PROFESSIONAL 60 Serie Mode D'emploi page 19

Wiring the Hood with a
Remote Blower
Depending on preference and ducting situation, these
blowers can be mounted on the roof or exterior wall of the
home. An exterior installation may be more appealing to
reduce noise in the kitchen.
For complete installation instructions see the instructions
supplied with the blower unit.
inches (mm)
2⅛"
(54)
1⅞"
(48)
6½"
(165)
12⅞"
(327)
1. Remove junction box channel covering the wires (see
Figure 13 on page 13).
2. Remove circular knockouts (Figure 13 on page 13).
3. Install strain relief (not included) into one of the circular
knockouts.
Installation Instructions
13⅝"
(346)
2⅛"
(54)
12⅛"
(308)
dia.9⅞"
(251)
20¾"
(527)
10"
(254)
19⅞"
(505)
Figure 26: Remote Blower
4. Install 1'' (25.4 mm) conduit connectors.
5. Run black, white, and green wires (#12 AWG) in 1''
(25.4 mm) conduit from the power supply to the
junction box.
6. Connect the power supply wires to the hood wires in
the following order: black to black, white to white, and
green wire to green ground screw on chassis. Use
spring type wire nuts.
• Spring type wire nuts, rated for a minimum of two
(2) #18 gauge wires and maximum of four (4) #14
gauge wires, UL & CSA rated to 600V and 302°F
(150°C).
7. Connect the "pigtail" to the connector inside the
junction box.
SPEED 1 RD
SPEED 2 BU
SPEED 3 BN
NEUTRAL WH
WH / BC / BL (16 AWG)
BK / N / NE (16 AWG)
120V, 60HZ, 20A
POWER SUPPLY
Figure 27: Wiring the Hood with a Remote Blower
8. Close the junction box cover.
9. Run five (5) #14 AWG wires in 1'' (25.4 mm) conduit
from the remote blower to the second conduit
connector.
10. Connect the remote blower to the pigtail wires as per
Figure 27. Connect the remote blower green (ground)
wire to the ground screw in the junction box. Refer to
the blower installation instructions for further wiring
details.
SP4
Brown Brown Brown
Green/Yellow Green/Yellow Green/Yellow
GROUND
White White White
N
SP1
Red Red Red
Blue Blue Blue
SP2
Orange Orange Orange
SP3
English | 18 |