Thermador PROFESSIONAL 60 Serie Mode D'emploi page 12

1. To change to horizontal discharge, move the discharge
cover, shown in Figure 5, to the top of the hood. The
plate is held in place by (4) 3/8'' hex nuts.
Assembly of the Transition
The supplied transition mounts to the top or rear of the
hood, depending on the discharge direction.
7½" 7½" 7½"
(190) (190) (190)
25½" 25½" 25½"
(647) (647) (647)
18" 18" 18"
(457) (457) (457)
Installation Instructions
Figure 5: Discharge Direction
inches (mm)
Figure 6: Transition Dimensions
A minimum height clearance of 7½'' (190 mm) is needed
above the hood for transition mounting. See "Before You
Begin" on page 5 for overall hood dimensions.
2. Depending on direction of discharge, align mounting
holes at base of transition with the mounting holes of
the ½'' (13 mm) flange located at the top or rear of the
hood.
3. Fasten transition to hood using four (4) 1/4'' (6 mm)
sheet metal screws included with hood (Figure 7).
4. Seal connection between transition and hood with
aluminum tape. DO NOT use duct tape. Ensure that
the connection is completely sealed (Figure 7).
5. Remove tape holding damper closed.
Figure 7: Transition Connection
English | 11 |