FLUX FEM 4070 Instructions D'installation page 3

Barrel Pump Motor FEM 4070
Installation of replacement electronics
The electronics is suitable for all versions of the FEM 4070.
With or without no-volt release (table1)
and the different voltages (table 2).
Observe the operating instructions of collector motors.
Observe the spare parts illustration.
Before installing the electronics compare the settings with the name plate.
Delivery status of the electronics:
No-volt release: On (U<)
Voltage: 230 V / 240 V
Should this setting not comply with the values on the name plate, adjust die
bridge and the dip switch according to table 1 and 2.
The settings may only be changed by qualified persons (electricians).
If the settings do not comply with the name plate the motor must not be
started.
Avoid electrostatic charge!
Talweg 12 ·
Telefon: 07043 101-0 · Telefax: 07043 101-444
Fax International:
info@flux-pumpen.de · www.flux-pumpen.de
75433 Maulbronn
· + 49 7043 101-555