Sony CPD-L133 Mode D'emploi page 27

Step 3: Attaching the rear cover
After connecting the computer and power cord, attach the
supplied rear cover.
Make sure that you keep the screen upright when attaching
the rear cover.
1
Hook the computer cable and power cord.
2
Insert the tabs on the back of the rear cover into the
catches, and then push down.
3
Turn the screw to fasten the rear cover.
Unlocked
Step 4: Turning on the monitor and
computer
First turn on the monitor, then turn on the computer.
The installation of your monitor is complete.
Note
If "OUT OF SCAN RANGE" or "NO INPUT SIGNAL" appears on
the screen, see "Warning Messages" on page 18.
For customers using Windows 95/98
To maximize the potential of your monitor, install the new model
information file from the supplied Windows Monitor Information
Disk/Utility Disk onto your PC.
This monitor complies with the "VESA DDC" Plug & Play standard.
If your PC/graphics board complies with DDC, select "Plug & Play
Monitor (VESA DDC)" or this monitor's model name as the
monitor type in the "Control Panel" of Windows 95/98. If your
PC/graphics board has difficulty communicating with this monitor,
load the Windows Monitor Information Disk/Utility Disk and
select this monitor's model name as the monitor type.
For customers using Windows NT4.0
Monitor setup in Windows NT4.0 is different from Windows 95/98
and does not involve the selection of monitor type. Refer to the
Windows NT4.0 instruction manual for further details on adjusting
the resolution, refresh rate, and number of colors.
Locked
Getting Started
Getting Started
EN
F
D
ES
I
7