Bosch GDS 18V-450 HC Professional Notice Originale page 15

plode. Ensure the area is well ventilated and seek medical
attention should you experience any adverse effects. The
vapours may irritate the respiratory system.
Do not open the battery. There is a risk of short-circuit-
u
ing.
The battery can be damaged by pointed objects such
u
as nails or screwdrivers or by force applied externally.
An internal short circuit may occur, causing the battery to
burn, smoke, explode or overheat.
Only use the battery with products from the manufac-
u
turer. This is the only way in which you can protect the
battery against dangerous overload.
Protect the battery against heat, e.g. against
continuous intense sunlight, fire, dirt, water
and moisture. There is a risk of explosion and
short-circuiting.
Application tools can become hot during operation.
u
There is a risk of burns when changing the application
tool. Use protective gloves to remove the application
tool.
Caution! When using the power tool with Bluetooth
u
fault may occur in other devices and systems, aero-
planes and medical devices (e.g. pacemakers, hearing
aids). Also, damage to people and animals in the im-
mediate vicinity cannot be completely excluded. Do
not use the power tool with Bluetooth
medical devices, petrol stations, chemical plants,
areas with a potentially explosive atmosphere or in
blasting areas. Do not use the power tool with
®
Bluetooth in aircraft. Avoid using the product near
your body for extended periods.
The Bluetooth® word mark and logos are registered trade-
marks owned by Bluetooth SIG, Inc. and any use of such
marks by Robert Bosch Power Tools GmbH is under li-
cense.
WARNING
Only use the coin cells listed in this operating manual.
u
Do not use any other coin cells or other forms of electrical
power supply.
Technical Data
Cordless Impact Wrench
Article number
Rated voltage
A)
No-load speed
– Setting 1
– Setting 2
Bosch Power Tools
Product Description and
Specifications
Please observe the illustrations at the beginning of this oper-
ating manual.
Intended Use
The machine is intended for driving in and loosening screws
and bolts as well as for tightening and loosening nuts within
the respective range of dimension.
With the Bluetooth
data and settings can be transferred between the power tool
and a mobile device by means of Bluetooth
logy.
Product features
The numbering of the product features refers to the diagram
®
, a
of the power tool on the graphics page.
(1) Tool holder
(2) Rotational direction switch
(3) Bluetooth® Low Energy Module cover
®
in the vicinity of
(4) Belt clip
(5) Rechargeable battery
(6) Battery release button
(7) User interface
(8) On/off switch
(9) Handle (insulated gripping surface)
(10) Application tool (e.g. impact socket)
User interface
(11) Status indicator for power tool
(12) Mode indicator
(13) Mode button
(14) Worklight
(15) Speed button
(16) Speed preselection indicator
a) Accessories shown or described are not included with the
product as standard. You can find the complete selection of
accessories in our accessories range.
V=
-1
min
-1
min
Read all the safety and general instructions.
Failure to observe the safety and general in-
structions may result in electric shock, fire
and/or serious injury.
®
Low Energy Module inserted, power tool
a)
a)
GDS 18V-450 HC
3 601 JK4 0..
18
1 000
1 500
1 609 92A 7YM | (31.05.2022)
English | 15
®
wireless techno-
a)
GDS 18V-450 PC
3 601 JK4 1..
18
1 000
1 500