Maintenance - BABYTREND JG30 Manuel D'instructions

MAINTENANCE

CARE AND MAINTENANCE
TESTING FOR PROPER WHEEL
INSTALLATION
WARNING:
check the double nut locking
system before each use to
ensure that the front wheel
is securely fastened to the
frame.
• Lift the front wheel off of the ground and
21)
sharply strike the top of the tire (Fig. 21).
The wheel should not be loose or come off.
If you experience front wheel wobble
that is beyond what is normal for use
while walking or jogging you may have
to adjust the front wheel housing nut.
• Remove footrest to access nut. You
22)
can use a standard crescent wrench to
tighten the nut (Fig. 22).
DO NOT OVER TIGHTEN this can
cause damage to the wheel housing.
FENDER
If adjustment or replacement is necessary:
• Line up the front fender and press onto
23)
the front frame assembly (Fig. 23a).
• Insert the 4 screws through the front
frame assembly into the front fender's
plastic tubes. Tighten the screws only
until snug (Fig. 23b).
DO NOT OVER TIGHTEN.
15
Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
ALWAYS
Fig. 21
Fig. 22
Fig. 23a
Screws
Fig. 23b
SEAT PAD
• To clean the seat pad, use only mild
household soap or detergent and warm
water on a sponge or clean cloth.
OTHER
• Check your stroller for loose screws,
worn parts, torn material or stitching on
a regular basis. Replace or repair parts
as needed.
Copyright © 2016, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
MAINTENANCE
16