Using The System (Lock/Unlock Function); Arm/Lock; Disarm/Unlock; Start Engine - Automate 7115A Manuel D'utilisation

Using the System (Lock/Unlock Function)

Arm/Lock

Press and release the remote control button. The vehicle doors
lock, siren/horn sound, parking lights flash once, and alarm* fea-
tures are enabled. If a Trigger Zone Fault is detected, the siren
chirps once again, and the Control Center LED generates a Trig-
ger Fault Zone report.*

Disarm/Unlock

Press and release the remote control button, then press and release
it a second time. The vehicle doors unlock, siren/horn sound,
parking lights flash twice, and alarm* features are disabled. An
Alarm Report* alert of four or five siren chirps will replace the
normal disarm chirps, if the alarm was triggered.

Start Engine

When the engine is OFF, press and hold the remote control button
to start the engine. If the remote start fails to turn on, the vehicle
parking lights will flash to indicate the cause. Refer to the following
table for the likely cause.
Alert Conditions:
Parking Light
Flashes*
5
6
7
9
* Available for systems with security features only.
© 2017 Directed. All rights reserved.
Possible Cause
Brake ON.
Hood Open.
After performing Remote Start
command MTS not enabled.
Start Valet ON.
Solution
Release Foot Brake.
Close Hood.
Enabled MTS Mode.
Turn Start Valet OFF.
5