Troubleshooting Guide - Kärcher IVM 35/17-2 Hepa Mode D'emploi

1. Remove the suction head, see
chapter Removing the suction
head.
2. Remove the adapter ring.
3. Release the strap.
4. Remove the filter unit from the de-
vice using the handles and turn it
over.
5. Remove the screws and remove the
cleaning fixture.
6. Loosen the clamping ring screw
connection.
7. Remove the pocket filter.
8. Fit the new pocket filter.
On installation, take care to ensure
that the lug on the filter inlay enga-
ges the shaft.
9. Fit the clamping ring and tighten the
screw connection.
10.Fit the cleaning fixture and tighten
the screw connection.

Troubleshooting guide

Danger of injury
Danger of the device unintentionally
starting and danger of electric shock
Have all checks and work on electrical
parts performed by a technical specia-
list.
Switch off the device and unplug the
mains plug before performing any work
on the device.
The motor (suction turbine) does
not start up
No electrical voltage present
 Check the socket and the power
supply fuse.
 Check the mains cable and the
mains plug of the device.
Customer Service department
If the malfunction cannot be corrected,
the device must be checked by the
Customer Service department.
en_us 9