Programming; Setting The Parameters - LEGRAND 261 93 Mode D'emploi

7. Programming

7.1 Setting the parameters

• Press the H and E keys together for 5 consecutive
seconds to start programming
• The flashing LED of the E key indicates that pro-
gramming is in progress
• Main line display indicates the parameter selected
via the code (for instance P0.01)
• Secondary line display indicates the set value of
the selected parameter (for instance 400)
• Changing of parameters of the same group by
pressing the key A
• Movement to next group with key E
• Movement to previous group with key H
A
Key
It moves
at same level
• Enable modification of the parameter with key B
• Increase the value of the selected parameter with
key F
• Decrease the value of the selected parameter with
key G
• Confirm by pressing key B
• While modifying a parameter, the secondary line
display flashes with the current value of the param-
eter. In this situation it is not possible to move to
another parameter without first confirming
• Exit from Setup by pressing E and H simultaneously
B
Key
- Enable modification
- Confirms setup
Key
- Goes to Setup
- Exits to higher level
Key
Increases parameter value
Key
Decreases parameter value
Key
Goes to lower level
E
F
G
H
15