JVC KD-R841BT Manuel D'instructions page 21

Wiring connection
KD-R841BT KD-R741BT
Front output
Rear/subwoofer output
MIC (Microphone input terminal) (➜ 9)
To the steering wheel remote control adapter
For some VW/Audi or Opel (Vauxhall)
automobiles
You may need to modify the wiring of the supplied
wiring harness D as illustrated.
If the unit does not turn on with modified wiring 1,
use modified wiring 2 instead.
Y: Yellow R: Red
Original wiring
Modified wiring 1
( or )
Modified wiring 2
Signal cord
(not supplied)
Rear/subwoofer output
Rear ground terminal
Aerial terminal
Light blue/yellow
STEERING
WHEEL
REMOTE
If your car has an ISO terminal
( or )
If your car does NOT have an ISO terminal
* Custom wiring harness (separately purchased)
IMPORTANT: A custom wiring harness (separately
purchased) which is suitable for your car is
recommended for connection.
Remote wire
To Blue/white
(not supplied)
wire of the wiring
harness D
JVC Amplifier
Fuse (10 A)
ISO connector
A4: Yellow: Battery
A5: Blue/white: Remote wire
A6: Orange/white: Car light control
switch
A7: Red: Ignition (ACC)
A8: Black: Earth (ground) connection
B1: Purple ª
Rear speaker
B2: Purple/black ·
(right)
B3: Gray ª
Front speaker
B4: Gray/black ·
(right)
B5: White ª
Front speaker
B6: White/black ·
(left)
B7: Green ª
Rear speaker
B8: Green/black ·
(left)
19
Part list for installation
A Faceplate
( ×1 )
B Mounting sleeve
( ×1 )
C Trim plate
( ×1 )
D Wiring harness
( ×1 )
E Extraction key
( ×2 )
ENGLISH