Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY
1. Take out parts for assembling.
2. Feed the power cord through the hole of base, stand the support on the base and tighten the
screw.
3. Put the base and support on a desk or flat surface. Make sure the connection part below the
support is aligned with the holes and then connect the fan head with the support by tighten-
ing the screw.
4. Attach the rear grid to the motor by tightening the grid clamping screw.
5. Fit the fan blade to the motor axle and tighten the blade screw.
6. Join grid ring and rear grid together. Bring grid ring into the correct position and tighten
using the grid clamping screw. Before switching the device on, make sure the grid is securely
tightened.
Step 1
Step 2
Step 4
Step 5
Step 3
Changing the fan height
1. Remove the fan body from the tube after loosening the butterfly screw.
2. Loosen the pipe screw and take out the long tube, then attach the short tube to the base and
tighten the screw.
3. Attach the fan body to the top of the tube and tighten the butterfly screw.
4. Reference Step 8 when attaching the long tube.
5. Reference Step 9 when attaching the short tube.
Step 6
Step 7
Step 8
OPERATION
Function buttons on remote control and main control panel
Plug in the fan. It enters standby mode after two "beep" sounds.
STANDBY MODE
When in standby mode, the only available function is the
to switch the fan on. Press it again to switch the fan off.
FAN SPEED
Press
"SPEED" to select the fan speed (3 speed modes)
MODE
Press
"MODE" to change between Normal/Nature/Sleep -> Normal
42 43
"ON/OFF" key. Press
"ON/OFF"
Publicité
