Safety Information For The Installer - Sentiotec HOME-C60 Mode D'emploi

Instructions for installation and use

2.2. Safety information for the installer

● Installing and connecting the sauna heater may only be performed
when the power supply is disconnected.
● Installation may only be performed by a qualified electrician or
similarly qualified person.
● A fully disconnecting all-pole isolating device compliant with
overvoltage category III must be fitted on site.
● Always use silicone cables that are heat-resistant up to 150 °C
to connect the sauna heater.
● Only install one sauna heater in the cabin. The Home fin sauna
heater must not be used together with other sauna heaters in
a sauna cabin.
● The roof and walls of the sauna cabin must be manufactured from
low-resin, untreated or thermally treated wood, e.g. Nordic spruce,
hemlock, pine or fir, or from laminated wooden materials. If lami-
nated wooden materials are used, make sure that the adhesive
used in them does not give off formaldehyde. If other materials
than wood are used in the sauna cabin, these materials must be
heat-resistant and corrosion-resistant and must not cause any
negative effects on the health of the sauna users.
● The height of the sauna cabin must be at least 1.9 m.
● Observe the specifications on volumes and on ventilation of
the sauna cabin in chapter 10. Technical data on page 25.
● When positioning the sauna heater, observe the minimum safety
distances (see chapter 4.2. Safety distances).
● Also comply with the regulations applicable at the installation
location.
● For your own safety, consult your supplier in the event of prob-
lems that are not explained in sufficient detail in the installation
instructions.
p. 6/26