Tanita SC-240 Manuel D'utilisation page 23

- Transmit data
(1) Output example (in the case to kg unit)
Note
• The data are divided with commas (,) for each data.
• The terminator (end of the data) is CR (ASCII code 0DH), LF (ASCII code 0AH).
• The control data for the items 1 – 4 are for expansion. They are not used presently so the receiving
side can ignore them.
• Because of its specifications, the scale will output an irrelevant signal approximately 0.1 second
after data output. Make sure you ignore this signal and do not import it.
Transmission Data is output immediately after measurement regardless of
the status of the receiving equipment (personal computer, etc.). Therefore
the receiving equipment needs to be ready to accept the data before
measuring.
23