Makita UR101C Manuel D'instruction page 11

3. Place the handle between the handle clamp and
handle holder.
4.
Temporarily attach the handle by tightening the
knob, and adjust the handle position.
5. Fully tighten the knob.
For UR201C
1. Attach the upper and lower clamps on the damper.
2. Put the handle on the upper clamp and fix it with
hex socket head bolts as illustrated.
1
► 1. Hex socket head bolt 2. Handle 3. Upper clamp
4. Damper 5. Lower clamp
Attaching the barrier
For the loop handle model only (country specific)
If the barrier is included in your model, attach it to the
handle using the screw on the barrier.
► 1. Barrier 2. Screw
CAUTION:
After assembling the barrier, do
not remove it. The barrier works as a safety part
to prevent you from contacting the cutting blade
accidentally.
2 3
4
5
1
2
Hex wrench storage
CAUTION:
Be careful not to leave the hex
wrench inserted in the tool head. It may cause
injury and/or damage to the tool.
When not in use, store the hex wrench as illustrated to
keep it from being lost.
► 1. Hex wrench
For the bike handle model, the hex wrench can be
stored on the handle clamp as illustrated.
2
► 1. Hex wrench 2. Handle clamp
For the loop handle model, the hex wrench can be
stored on the handle as illustrated.
► 1. Hex wrench
11 ENGLISH
1
1
1