Télécharger Imprimer la page

Antar AT51031 Mode D'emploi page 10

Publicité

Les langues disponibles

Les langues disponibles

SETTING AND OPERATING THE BRAKES
Service brake (when sliding): Pull the
brake levers upwards.
Parking brake (when parking): Push the
brake levers down. (see Fig. 5).
NOTE: In case of any uncertainties, please contact Customer Service. Changes in the brake
settings can lead to reduced braking force.
FOLDING AND STORAGE OF THE ROLLATOR
1. Pull the strap up in the middle part of the
seat to fold the rollator - Fig. 7.
MAINTENANCE
1. Make sure that ALL equipment parts are always turned correctly.
2. Check that the screws, buttons and knobs of the wheels and the moving wheels are
screwed in. Check that the brake is working properly and that the handles are properly
secured.
3. Used or damaged parts must be replaced immediately.
CLEANING
To clean the rollator, use a damp cloth or sponge and warm water with soap. If necessary,
common disinfectants can also be used. Make sure that there is no water or detergent residue
soaked on the cleaned surfaces and that they are not smooth. Do not use rough detergents or
scratching devices - they can damage the paint layer.
Brake setting: To increase the voltage of the brake
rope, turn the control screw counterclockwise; then - to
maintain such a setting - turn the fastening button
clockwise and hold the control screw (see Fig. 6).
Fig. 6
Sperrung
Fig. 5
Fig. 7

Publicité

loading