Publicité
Les langues disponibles
Les langues disponibles
Connection to the Network
Setting the gas circuit dito service
Installation of the Wire
18
5, INSTA EL/111ON f1 NI) USE
Before connecting the welding set to the rietwork it is essential to check
that Ille voltage required for Ille set duly corresponds (o Ille mains pollage.
This operalion being correctly peiformed, the primary supply table of
the sel can be connected 10 a mains power socket or terminal.
Caution :
Never connect the green and
Ground r L
lu the 'nain terminais ; Ibis is designed (iii accordante
»)
with the standards in force) Io ground the set.
5
____________
2/ Replace the saletychain
3
5/ Open the gas cylinder
conductor (marked hie the
yen() w
1/
Place Ille gas ulinder coi the eylinder
support
31 Install the pressure reducer flow-Ineler
61 Set 1he gas flow rate bet1VCCJI
12 1 /min
71 !iule Ille mature reel
81 butai' the Coil of win
support pin
9/ Pull out about 10 coi of 'vire
101 Close the mobile devis of the
counter-reel.
S y M b o l
6
4/ Connec
and
Ill
,
on the coil
Publicité
