LEM ISO plus Manuel D'utilisation page 25

Programming functions
f) Default values programming
This function enables you to permanently program limits and settings so they are
maintained even after switching the instrument ON/OFF. This results in a
customised instrument.
The setting can only be changed in the respective functions (central switch position).
STORE user defined Parameters:
a) Continuity Level
Switch to Ohm position.
Press button. for continuity and afterwards
Big display shows .
The small display shows the actual continuity trigger level in a range from 0.1
to 50.0Ω. Incrementing steps are 0.1Ω within the range of 0.2Ω up to 5Ω -
from 5Ω to 50Ω stepping is 1Ω. Change the continuity level with the
and select the digit with key.
.
Confirming this display with the
without saving.
b) Limit value programming
Switch to desired measuring function.
Press the key twice - large display shows
The small display shows the LIMIT MIN value for the selected function (rotary switch
position). Use key to switch display to
function. Press again to the show LIMIT
Change the LIMIT MIN with the buttons
The entry is completed by pressing the
store LIMIT MIN and exit.
Press the key, the large display shows
between HI and LO limit.The small display shows the LIMIT MAX value or OFF
(same as above).
Change the LIMIT MAX with the buttons
The entry is completed by pressing the
.
exits and saves.Turn rotary switch
.
. In this display has no
(left most digit begins to flash) and
button or pressing button to
the key wraps arround
and .
button. Values are stored permanently.
- 25 -
key