Tubo Robo TR800 Manuel D'utilisation page 30

TROUBLESHOOTING
The following table lists a series of inconveniences that may occur when using
PROBLEM CAUSE
Main brush clogged
Main brush worn out
ROBÒ does not clean
Edge-sweeping side brushes
worn out
Filters very dirty or damaged
Insufficient water
EN
Micro-fibre cloth worn out; with
a worn cloth, water will not be
dispensed evenly resulting in
ROBÒ does not wash
streaks and dripping
the floors
Limescale residues inside the
floor mop tank
Other problem
Edge-sweeping side brushes
blocked
Main brush blocked
The anti-fall sensor is dirty
The side sensor is dirty
The front sensor is dirty
ROBÒ blocks during
The front collision guard is
cleaning
jammed
Side wheels blocked
Anti-fall sensors irradiated by direct
sunlight. The presence of direct
sunlight under the ROBO 'body
can activate false alarms to the
protection sensors.
14
ROBÒ. If the user cannot solve problem, contact Aertecnica (in Italy only) or the authorised foreign retailer.
ACTION
Check for any obstructions and clean the
main brush
Replace the brush
Replace the brushes
Clean the filters or replace them
Check the water in the tank
Replace the micro-fibre cloth
Replace the floor mop tank or remove the
limescale
Contact Aertecnica (for Italy only), or the
authorised foreign retailer
Check whether any filaments or objects
are blocking their rotation
Check whether any filaments or objects
are blocking its rotation
Clear the sensor from any dust or debris
Clear the sensor from any dust or debris
Clear the sensor from any dust or debris
Strike the collision guard repeatedly to
remove any debris
Clear the side wheels from any dust or
debris Push the wheels in and out and
check that they turn freely
It is recommended to shade the environment
with curtains or use the robot at times of the
day when solar radiation is weak.
PROBLEM CAUSE
The charging dock is not powered
The communication sensor of the
charging dock is dirty
ROBÒ does not return
to its base
ROBÒ communication sensor dirty
Other problem
Connection problem between the
charging dock and self-cleaning base
Connection problem between the
vacuum socket and self-cleaning base
With ROBÒ on the
self-cleaning base for
emptying the dust
container, the central
Connection problem regarding the
vacuum unit does not
central vacuum unit activation
start
consent
Other problem
Connection problem concerning
the activation consent between the
During the automatic
charging dock and the base
emptying of the dust
Valve obstructed
container, the valve on
the base fails to open
Other problem
The automatic cleaning function of
When ROBÒ returns
the dust container is disabled
to the self-cleaning
base, it does not The communication sensor of the
automatically activate charging dock is dirty
emptying of the dust
container
Other problem
ROBÒ TR800 Instruction Manual
ACTION
Check the power supply connection
Clear the sensor from any dust or debris
Clear the sensor from any dust or debris
Contact Aertecnica (for Italy only), or the
authorised foreign retailer
Verify whether the connector for the central
vacuum unit activation consent is properly
connected on the self-cleaning base
Check that the activation fitting is properly
inserted on the vacuum socket
If there is a wireless system
Verify whether the transmitter is correctly
inserted on the self-cleaning base: at the start
and end of the dust container emptying cycle,
the transmitter's LED flashes red
If there is a wireless system
Check the pairing configuration between the
transmitter and receiver
Contact Aertecnica (for Italy only), or the
authorised foreign retailer
Check that the charging dock and base are
properly connected to one another
Check for any debris on the valve and eliminate it
Contact Aertecnica (for Italy only), or the
authorised foreign retailer
Enable the container's automatic cleaning
function (see instructions on page 6)
Clear the sensor from any dust or debris
Contact Aertecnica (for Italy only), or the
authorised foreign retailer
EN