Publicité
Les langues disponibles
Les langues disponibles
CLEANING / REPLACING THE FILTERS
Visit the tutorial area dedicated to ROBÒ on www.aertecnica.com
HEPA FILTER AND SPONGE FILTER
1 - Remove the dust container and open the flap
(S) of the filter compartment.
2 - Extract the HEPA filter (H) and the sponge
filter (F).
3 - Clean each filter thoroughly by removing dirt
residues.
EN
WARNING
Filters should not be washed
PRIMARY FILTER
1 - Open the dust container, empty it and clean
it thoroughly.
2 - Extract the primary filter (G) by pulling the
two rings on the side (W).
3 - Clean the filter thoroughly by removing dirt
residues.
WARNING
Filters should not be washed
Wear personal protective garments
before emptying the dust container or
cleaning the filters and brushes.
12
H
S
F
G
W
CLEANING / REPLACING THE BRUSHES
Visit the tutorial area dedicated to ROBÒ on
www.aertecnica.com
We recommend using the comb (C) supplied with ROBÒ.
CLEANING THE MAIN BRUSH
1 - Open the cover (Q) using the two levers (L).
2 - Extract the main brush (R) from its housing.
3 - Thoroughly clean the bristles of the brush
by removing hair, threads and residues with the
comb (C) supplied.
4 - Put the brush back into its housing and close
the cover.
CLEANING THE EDGE-SWEEPING SIDE BRUSHES
1 - Extract the edge-sweeping brushes by
simultaneously pulling the side bristles with your
hands.
2 - Thoroughly clean the bristles by removing
hair, threads and residues with the comb (C)
supplied.
C
3 - Put the brushes back in place by applying
pressure and observing the L (Left) and R
(Right) positions indicated on the bristle supports.
WARNING
Check the integrity of the brushes and
replace them it they are broken.
ROBÒ TR800 Instruction Manual
L
Q
R
C
RIGHT
LEFT
Wear personal protective garments
before emptying the dust container or
cleaning the filters and brushes.
EN
Publicité
