Publicité
Les langues disponibles
Les langues disponibles
CLEANING THE SENSORS
Visit the tutorial area dedicated to ROBÒ on
www.aertecnica.com
Use a damp cloth to clean all the sensors and
indicated charging contacts on ROBÒ and on the
charging dock.
Do not use solvents or chemical products.
EN
CLEANING THE WHEELS
Thoroughly clean the wheels by removing
hair, threads and residues using the comb
supplied.
Use a screwdriver to extract the front
wheel and clean the residues properly, as
shown in the picture.
WARNING
Check the integrity of the brushes and
replace them it they are broken.
13
Wear personal protective garments
before emptying the dust container or
cleaning the filters and brushes.
TANK WITH WATER DISPENSER
Before using the FLOOR WASHING mode, the
tank with the water dispenser must be filled
with water and then emptied at the end of the
washing cycle.
TANK FILLING
1 - Extract the dust container (A) to insert the
tank with the water dispenser (B).
2 - Open the cap (T) located on the top side of
the tank.
3 - Pour water into the tank using a suitable
container (W) and close the cap.
WARNING
The tank with dispenser must be filled with
water alone (at 30°C).
INSERTING THE MICRO-FIBRE CLOTH (MOP)
4 - Apply the floor mop provided (P) on the
bottom side of the tank (B), making sure that the
strips adhere properly to the Velcro fasteners (D).
6 - Insert the tank again all the way down until
you hear a CLICK.
ROBÒ will now be ready to wash the floors.
WARNING
Once the washing cycle terminates, empty the
tank of any residual water and wash the micro-
fibre cloth.
PLEASE NOTE
With the TUBÒ ROBÒ app it is possible to choose
the level of water dispensed to the MOP.
ROBÒ TR800 Instruction Manual
A
B
T
EN
P
D
B
Publicité
