Troubleshooting Guide - Hatco MDW Série Manuel D'installation

English
WARNING
This unit must be serviced by qualified personnel only.
Service by unqualified personnel may lead to electric
shock or burn.
Symptom
Light bulb not working.
Unit too hot.
No heat, but light works.
Unit not hot enough.
Unit not working at all.
Troubleshooting Questions?
If you continue to have problems resolving an issue, please con-
tact the nearest authorized Hatco Service agency or Hatco for
assistance. To locate the nearest Service agency, log onto the
Hatco website at www.hatcocorp.com and click on
Find Service Agent, or contact the Hatco Parts and Service
Team at:
Form No. MDWM-1214
Probable Cause
Light bulb defective.
Unit not turned on.
Temperature Control set too high.
Unit connected to incorrect power supply.
Temperature Control is defective.
Temperature Control set too low.
Heating element(s) not working.
Temperature Control is defective.
Unit not allowed enough time to preheat.
Temperature Control set too low.
Door(s) not closed completely.
air circulating fan not working properly.
Heating element(s) not working.
Temperature Control is defective.
Unit not plugged in.
Unit not turned on.
Circuit breaker tripped.
Power I/O (on/off) switch defective.

TROUBLESHOOTING GUIDE

ELECTRIC SHOCK HAzARD: Turn OFF power switch,
unplug power cord, and allow unit to cool before
performing any cleaning, adjustments, or maintenance.
Replace
MaINTENaNCE section.
Move Power I/O (on/off) switch to the I (on)
position.
adjust the Temperature Control to a lower
setting.
Verify with qualified personnel that power
supply matches unit specification.
Contact an authorized Hatco Service agent or
Hatco for assistance.
adjust Temperature Control to a higher
setting.
Contact an authorized Hatco Service agent or
Hatco for assistance.
Contact an authorized Hatco Service agent or
Hatco for assistance.
allow unit 30 minutes to reach operating
temperature.
adjust the Temperature Control to a higher
setting.
Make sure all doors are closed completely.
Contact an authorized Hatco Service agent or
Hatco for assistance.
Contact an authorized Hatco Service agent or
Hatco for assistance.
Contact an authorized Hatco Service agent or
Hatco for assistance.
Plug unit into proper power supply.
Move Power I/O (on/off) switch to the I (on)
position.
Reset circuit breaker. If circuit breaker
continues to trip, contact an authorized Hatco
Service agent or Hatco for assistance.
Contact an authorized Hatco Service agent or
Hatco for assistance.
Telephone: 800-558-0607 or 414-671-6350
e-mail: partsandservice@hatcocorp.com
Fax: 800-690-2966 or 414-671-3976
11
WARNING
Corrective Action
light bulb. Refer to the