Maintenance; General; Daily Cleaning - Hatco MDW Série Manuel D'installation

English

General

The Hatco Mini Display Warmer is designed for maximum
durability and performance, with minimum maintenance.
WARNING
ELECTRIC SHOCK HAzARD:
• Turn OFF power switch, unplug power cord, and allow
unit to cool before
adjustments, or maintenance.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• Do not steam clean or use excessive water on unit.
• This unit is not "jet-proof" construction. Do not use jet-
clean spray to clean this unit.
• Do not clean unit when it is energized or hot.
This unit has no "user-serviceable" parts. If service is
required on this unit, contact an Authorized Hatco Service
Agent or contact the Hatco Service Department at
800-558-0607 or 414-671-6350; fax 800-690-2966; or
International fax 414-671-3976.

Daily Cleaning

To preserve the finish of the Mini Display Warmer, perform the
following cleaning procedure daily.
NOTICE
Use non-abrasive cleaners and cloths only. Abrasive
cleaners and cloths could scratch finish of unit, marring its
appearance and making it susceptible to soil accumulation.
1. Turn off the unit, unplug the power cord, and allow the unit
to cool.
2. Remove and wash all food pans.
3. Wipe down all interior and exterior metal surfaces with a
damp cloth. Stubborn stains may be removed with a good
non-abrasive cleaner. Clean hard to reach areas using a
small brush and mild soap.
4. Clean the glass side panels and door panel(s) using ordinary
glass cleaner and a damp, soft cloth or paper towel. The
side panels are removable for detailed cleaning, if
necessary. Refer to the "Removing a Glass Panel"
procedure in this section for removal.
Form No. MDWM-1214
performing any cleaning,
Removing a Glass Panel
1. While holding the glass panel securely, remove the screws
holding one of the glass brackets to the unit.
2. Carefully lift the glass panel off the unit and set in a safe
place with the screws.
Installing a Glass Panel
1. Slide the glass panel into the groove of the installed glass
bracket.
2. While holding the glass panel securely, reinstall the
removed glass bracket to the unit.
Glass Panel
Glass Panel Removal
9

MAINTENANCE

Screw
Glass Bracket