Klarstein ENERGIEWENDE Mode D'emploi page 66

EN
Cleaning the ash grid
Check the ash grid regularly before use. Make sure it is free of ash, soot or
slag. The ash grid should be placed correctly in the chamber. When the ash grid
has cooled to room temperature and the ash has cooled, you can use an ash
extractor to extract the ash.
Dirty Grid Clean Grid
Cleaning the bottom of the ash grid
When you clean the ash grid, also check the floor underneath. If there is too
much ash, the amount of oxygen in the chamber will be reduced, causing poor
combustion. Once the ash has cooled, you can use an ash extractor to extract
the ash.
Dirty floor Clean floor
66