Benchmark BW4400 Mode D'emploi page 43

7.4 LONG TERM STORAGE - ENGINE
Before storing the pressure washer set for an extended period:
Ensure that the storage area is free of excess humidity and dust.
Drain the fuel tank and the carburetor.
Storage Duration
Less than 1 Month
1 Month to 1 Year
1 Year or More
Preparation Required
No storage preparation required, simply store
as is.
Drain the old gas and completely fill the tank
with fresh gas before storage. Add fuel stabilizer
according to the manufacturer's directions. Run
the engine outdoors for 5-10 minutes to ensure
the stabilized gas has replaced the untreated
gas in the carburetor. Adding a quality fuel
stabilizer can keep gas fresh for up to a year.
Drain off the gasoline from the fuel tank, and store
in a suitable container. This will help prevent
deposits from forming in the fuel system.
Turn the fuel switch to OPEN and loosen the
carburetor drain bolt. Take off the spark plug cap
and revolve the engine 3 or 4 times, by pulling the
recoil handle, to fully discharge the gasoline from
the fuel lines.
Turn the fuel switch to CLOSED and tighten the
drain bolt of the carburetor.
Change oil while engine is still warm from
operation.
Remove the spark plug, and pour a tablespoon
of clean engine oil (10~20ml) into the cylinder.
Revolve the engine several times by pulling on
the recoil start to distribute the oil. Reinstall the
spark plug. Pull the starter grip slowly until you feel
resistance. At this point, the piston is coming up
on its compression stroke and both the intake and
exhaust valves are closed. This position helps to
protect the engine from internal corrosion.
36
BW SERIES