Using Your Pressure Washer; Using The Spray Wand - Benchmark BW4400 Mode D'emploi

5. USING YOUR PRESSURE WASHER

DANGER!
NEVER direct the water flow at people. The high pressure jet can be
4
dangerous if misused and must not be directed at people, animals,
electrical devices or the unit itself. DO NOT TREAT FLUID INJECTION AS
A SIMPLE CUT! Seek medical help immediately.
WARNING!
Do not run the pump without connecting to the water supply and turning
the water on. Failure to do so could damage the pressure washer. Failure
to follow these instructions will void product warranty.
Water that passes through this unit is not drinking water safe.
Note
DO NOT allow the unit to run for more than 2 minutes without the gun
trigger being pulled. This could cause overheating and damage to the
pump. When the temperature inside the pump gets too high the thermal
relief valve will temporarily open and release a spray of water from the
pump to lower the internal temperature.

5.1. USING THE SPRAY WAND

1. Flip the safety up to remove it.
2. Pull back on the trigger to begin operating pressure washer.
3. To stop water flow, release the trigger.
5
19