Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
LoRaWAN SENSORS- Mode d'emploi / User guide version V2.0
•
Finish the assembly by locking the packing gland's nut in position
Packing gland nut
2.7. Starting up the product using a magnet
Once the product has been configured and its assembly has been finalised, the product is ready to be started up.
The start-up is carried out using a magnet which you place on the upper part of the product (cf. the diagram below). The magnet must be held
in position for at least 6 seconds so as to confirm the start-up of the product.
Once the LoRaWAN Sensors unit validates its start-up, it immediately transmits status frames followed by a data frame (according the defined
periodicity).
NB : Once the LoRaWAN Sensors unit has started up, it cannot be switched off.
Position of the magnet for
starting up the product
Page
GB
38
of 45
Publicité
Table des Matières
