Makita GA4552 Manuel D'instruction page 10

► 1. Lock nut 2. Abrasive cut-off wheel / diamond
wheel 3. Inner flange 4. Wheel guard for abrasive
cut-off wheel / diamond wheel
As for the installation, follow the instructions for
depressed center wheel.
The direction for mounting the lock nut and the
inner flange varies by wheel type and thickness.
Refer to the following figures.
When installing the abrasive cut-off wheel:
► 1. Lock nut 2. Abrasive cut-off wheel (Thinner than 4
mm (5/32")) 3. Abrasive cut-off wheel (4 mm (5/32")
or thicker) 4. Inner flange
When installing the diamond wheel:
► 1. Lock nut 2. Diamond wheel (Thinner than 4 mm
(5/32")) 3. Diamond wheel (4 mm (5/32") or thicker)
4. Inner flange
1
2
3
4
1 1
2 3
4 4
1 1
2 3
4 4
Operation with wire cup brush
Optional accessory
CAUTION:
Check operation of brush by run-
ning tool with no load, insuring that no one is in
front of or in line with brush.
CAUTION:
Do not use brush that is damaged,
or which is out of balance. Use of damaged brush
could increase potential for injury from contact with
broken brush wires.
► 1. Wire cup brush
Unplug tool and place it upside down allowing easy
access to spindle.
Remove any accessories on spindle. Thread wire cup
brush onto spindle and tighten with supplied wrench.
NOTICE:
Avoid applying too much pressure
which causes over bending of wires when using
brush. It may lead to premature breakage.
Operation with wire wheel brush
Optional accessory
CAUTION:
Check operation of wire wheel
brush by running tool with no load, insuring that
no one is in front of or in line with the wire wheel
brush.
CAUTION:
Do not use wire wheel brush that
is damaged, or which is out of balance. Use of
damaged wire wheel brush could increase potential
for injury from contact with broken wires.
CAUTION:
ALWAYS use guard with wire
wheel brushes, assuring diameter of wheel fits
inside guard. Wheel can shatter during use and
guard helps to reduce chances of personal injury.
10 ENGLISH
1