Ga.Ma GC542 Sport Manuel De L'utilisateur page 9

GC542 SPORT
RECOMMENDATIONS FOR USE:
Before using the hair clipper the hair must be clean and dry. We recommend cutting small quantities of hair at
a time, adjusting the cutting length gradually until finding the one you want. The blades risk getting stuck if too
fast movements are made or if a lot of hair is cut at the same time. It can be used without attachment comb to
trim beard, neck hair and sideburns.
BEFORE USING THE APPLIANCE:
Before charging the appliance for the first time we recommend fully discharging the battery and then fully
charging it.
1. Make sure that the appliance is switched off.
2. Plug the adapter into the USB port of your PC, Notebook or Tablet and then connect it to the device. A
standard USB adapter (5V 1000 mA) may be used. The charging LED will light up and remain red for the
whole charging process.
3. The first charge takes 12 hours. Subsequent charges take about 8 hours. When fully charged, the battery will
last about 45 minutes.
4. Once it is fully charged, disconnect the adapter from the USB port of your PC, Notebook or Tablet or from
the power outlet.
5. Thanks to its cord-cordless function the appliance may be used connected directly to the USB port or power
outlet if the battery charge is depleted.
The duration of the battery varies based on usage frequency and times. To increase the lifespan of the
batteries, this procedure should be carried out at least twice a year, discharging the battery completely and
recharging it for the maximum time. If the appliance is not used often, remember in any case to carry out a
charging cycle every so often during the year to keep it working efficiently. On the contrary, when the charging
is finished, do not keep the appliance connected to the mains to prevent the battery from overcharging and
damaging the appliance.
WARNING: Do not attempt to replace the internal battery of the hair clipper. This can lead to the risk of
fire or electric shock. Tampering invalidates the warranty on the product.
16
USE INSTRUCTIONS:
• Insert the supplied accessory. This operation should always be done with the hair clipper turned off.
• Turn on the hair clipper by pressing the (O/I) button.
• Turn off the hair clipper by pressing the (O/I) button.
INSERTION OF THE COMB:
The supplied comb has two bars, each with a guiding groove in the central part (Fig. 1). The hair clipper has
two guideways on the two sides, on the upper part of the body of the product (Fig. 2). To insert the comb in
the hair clipper, slide the bars of the comb on the guideway found on the body of the product until you hear a
slight click: insertion will be now be completed. To remove the comb, just extract it from its groove, applying
force to the hair clipper blade.
Fig.1 Fig.2
17