Assembly Instructions; Lubrication - Kobalt XC602000 Mode D'emploi

ASSEMBLY INSTRUCTIONS

FILTER
Install air filter (H) on pump (see Figure 10).
Filter styles may vary.

LUBRICATION

CAUTION
Inspect Before Use. Check for proper oil level
before operating!
Remove oil fill plug on pump. Check oil level;
some models are shipped with oil in the pump.
See specification label on compressor pump
for the proper oil capacity and oil type. Add oil if
needed. Place oil fill plug back on pump.
OIL INFORMATION
Kobalt Air Compressor Oil
Kobalt Synthetic Blend Oil
Mobil 1 synthetic 10W30
®
Oil Capacity
Do not use regular automotive oil. Additives in
regular motor oil can cause valve deposits and
reduce pump life.
For maximum pump life, drain and replace oil
after the first 50 hours of run time and then follow
the regular maintenance schedule outlined later
in the manual.
This pump has an oil sight glass as shown
in Figure 11. Oil level can be monitored and
maintained as shown in Figure 12.
PIPING
WARNING
Risk of Personal Injury. Never use plastic
(PVC) pipe for compressed air. Serious injury
or death could result.
Any tube, pipe, or hose used must have a pressure rating higher then 200 PSI. Minimum
recommended pipe size is 3/4 in. Larger diameter pipe is always better.
SKU 221008
SKU 221009
Approximately
54 ounces
13 13
10
11
Oil Drain
12
Sight Glass
H
Oil Fill
Plug
Sight
Plug Glass
Full
Low