Kobalt XC602000 Mode D'emploi page 11

INSTALLATION INSTRUCTIONS
2. Remove the pressure switch cover by loosening the
screw (see Figure 6). Use a Phillips screwdriver (not
included). Pressure switch styles may vary.
WARNING
Risk of Shock. All wiring and
electrical connections must be
performed by a qualified electrician
familiar with industrial motor
controls. Installations must be in
accordance with local and national
codes.
3. Familiarize yourself with the pressure switch once cover is removed.
7
Tank Pressure
Gauge
WARNING
All wiring and electrical connections should be
performed by a qualified electrician. Installation
must be in accordance with local codes and
national electrical codes.
If not properly grounded, this tool can
cause an electrical shock, particularly when used in
damp locations, in proximity of plumbing, outdoors.
ASME Safety
Valve
6
Motor Terminal
Ground
Line
Screw
Terminal
WARNING
Installation of grounding plug can result in electric
shock. When repair or replacement of the cord or plug
is required, do not connect the grounding wire to either
flat blade terminal. The wire with insulation having an
outer surface that is green with or without yellow stripes
is the grounding wire. Never connect green (or green
and yellow) wire to a live terminal.
11
Screw
Motor Power
Cord
Motor Cord Strain
Relief