Bosch PAS0720 Mode D'emploi page 38

Condensed water normally evaporates through
the outdoor unit. If there is too much water, it
may not be possible to expel it all. If this
happens, it accumulates on the base of the
outdoor unit and may drip. Do not worry, this is
normal. Simply place a receptacle beneath
nozzle C Fig. 2, and remove the accumulated
water.
When the water in tank Q, Fig. 1, reaches a
certain level, the appliance beeps for two
seconds and the tank full symbol
on the screen to indicate that it needs to be
emptied. The appliance stops working when
this happens. To empty the removable tank,
carefully remove it and empty it down the
nearest drain.
Important!
When you turn the appliance back on again,
do not forget to fit the tank back onto the
appliance properly. Should you fail to do so,
the symbol will not disappear from the screen
and the appliance will not work.
Remember that when the appliance is turned
off and turned back on, it is necessary to wait
for approximately 3 minutes before the
compressor starts up again. This period of time
is required in order to ensure correct appliance
operation.
Function dehumidification
In this operation function, the appliance
reduces the humidity in the atmosphere. The
appliance purifies the air in the room at the
same time in order to create a pleasant
atmosphere.
Check that there is no water in the outdoor
unit by removing plug C, Fig. 2. Put it back
in position after extracting the water.
Transport the outdoor and indoor units to the
room you wish to dehumidify. See
Transportation requirements.
Plug the appliance into the mains electricity
supply.
Lift air director A, Fig. 1, and, if you wish,
open side fins L, Fig. 1 (see "Side fins")
There are two ways of expelling condensed
water: via removable tank P, Fig. 1 and in
continuous mode.
Instructions for Use
Dehumidification via the removable tank:
• Check that the tank is fitted properly (the
symbol
that it is not) and that plug C, Fig. 2, is in
position to prevent water from leaking onto the
support surface.
• Select the dehumidification function (see
"Selecting the operation function").
• Select the operation speed, (see "Selecting
the speed").
appears
• The water level in the removable tank rises.
When it reaches its maximum level, the
appliance beeps for approximately two
seconds and the symbol
display screen.
• Extract the tank and pour the water carefully
down the nearest drain.
Dehumidification in continuous mode:
• Place a receptacle at the outlet of tube O,
Fig. 1 to collect the condensed water or
direct it to the nearest drain.
• Remove plug N, Fig. 1. When operating in
this mode, the appliance does not stop or
warn that the receptacle is full by beeping or
via the symbol
• Select the dehumidification function
"Selecting the operation function").
• Select the operation speed, (see "Selecting
the speed").
Important
The amount of water dehumidified may
vary depending on ambient conditions
(See "Technical Information").
When the appliance is operating in the
dehumidification function, the temperature
does not appear on the screen and cannot
be selected or modified.
Warning!
Do not forget to fit plug N, Fig. 1 when you
change function. Otherwise the appliance
will shed water when operated.
Remember that ambient temperature must
be 18ºC or higher in order for the appliance
to work.
In this operation function, room
temperature rises slightly.
38
on the display screen indicates
appears on the
.
(see