Bosch PAS0720 Mode D'emploi page 35

Pull the hose off its housing guides. Fig. 22.
In the event of the indoor and outdoor
units being disconnected for a long period
of time, protect the free end of the hose
against dirt and dust by fitting the
protection cap (See Fig 23).
Preparing the appliance before use
Fig. 21
Fig. 22
Fig. 23
Before connecting the two parts again, it is
recommended that you clean any dirt
which has built up on the indoor unit
connection with a clean, dry cloth.
Important!
To prevent the risk of refrigerant loss, we
do not recommend that the hose be left
disconnected from the indoor unit for more
than one day. Never operate the indoor unit
without the outdoor unit.
Joining the flexible hose to the
indoor unit
Connect the flexible hose back onto the indoor
unit by following the steps described above in
reverse order.
If the rubber cap is fitted on the free end of the
hose, remove it and position it as shown in
Fig. 24 before fitting the entire assembly onto
the indoor unit.
Important!
The hose has only one assembly position.
Make sure that the lever is secured by
safety tab A, Fig. 21. Only then is the
connection correct.
Make sure that the electrical connection is
covered by the cover and secured with the
relevant screw. Fig. 19.
Make sure that the water tube is fitted
properly to prevent water from dripping
onto the support surface. To do this, follow
the indications shown in Fig. 20 in reverse
order.
35
Fig. 24