Publicité
Les langues disponibles
Les langues disponibles
OBJ_BUCH-0000000331-002.book Page 17 Thursday, June 27, 2019 3:07 PM
Changing the tool.
Before mounting or replacing cutting tool or accessories, pull the power plug.
WARNING
This preventive safety measure rules out the danger of injuries through acciden-
tal starting of the power tool.
Mounting a grinding disc (figure 4).
Press the locking button only when the
motor is stopped.
Press the locking button completely through
and hold it in place. Loosen the clamping
flange with the pin-type face wrench.
Unscrew the clamping flange.
Replace the used-up grinding accessory
or insert a new one.
Fig. 4
1.
Pay attention that the grinding accessory
is properly centered between the sup-
port flange and the clamping flange.
Manually screw on the clamping flange again.
Press the locking button completely through
and hold it in place. Tighten the clamping
flange with the pin-type face wrench.
Note: Pay attention to the mounting direction
of the clamping flange, which can vary
depending on the thickness of the grinding
disc.
3.
2.
Support flange
4.
en
Clamping flange
6 mm
1/4 in
6 mm
1/4 in
17
Publicité
