Machine Installation; Uncrating Machine; Installing Batteries - Tennant 5400 Opérateur Manuel Et Liste Des Piéces

OPERATION

MACHINE INSTALLATION

UNCRATING MACHINE

1. Carefully check carton for signs of damage.
Report damages at once to carrier.
2. Check Carton Contents list, contact distributor for
missing items.
Carton Contents:
1 -- Battery Tray (#613971)
4 -- Batteries, 235 Ah 6V (#606897)
3 -- Battery Cables (#130364)
8 -- Battery Post Caps (#45962)
8 -- Black Battery Boots (#611221)
1 -- Squeegee Assembly (#612025)
2 -- Bumper Wheels (#1014918AM)
(Disc Scrub Head Model)
Scrub brushes, pad drivers and pads must be
purchased separately (See PARTS LIST section).
3. To uncrate your machine: unbolt rear of chassis
from shipping pallet, remove shipping straps and
carefully lift machine with assistance or use a
ramp to remove from pallet.
ATTENTION: Do not roll machine off pallet,
machine damage may occur.
ATTENTION: To prevent possible machine
damage, install batteries after removing machine
from shipping pallet.
4. Install bumper wheels on scrub head (Disc Scrub
Head Model).

INSTALLING BATTERIES

WARNING: Fire Or Explosion Hazard.
Batteries Emit Hydrogen Gas. Keep Sparks And
Open Flame Away. Keep Battery Hood Open When
Charging.
FOR SAFETY: When servicing machine, wear
protective gloves and eye protection when
handling batteries and battery cables. Avoid
contact with battery acid.
Recommended Battery Specifications:
Four 6 volt, deep cycle, 235 amp. hour batteries.
Maximum battery dimensions are 181 mm (7.13 in) W
x 260 mm (10.25 in) L x 292 mm (11.50 in) H.
8
Home Find... Go To..
1. Remove key from machine and set parking brake,
if equipped.
2. Hinge open recovery tank to access battery
compartment. Remove loose battery cables from
compartment (Figure 1).
FIG. 1
3. Carefully install batteries into battery compartment
tray and arrange battery posts as shown
(Figure 2).
Machine Front
BLACK
5
RED
4
FIG. 2
ATTENTION: Do not drop batteries into
compartment, battery and machine housing
damage may result. This damage is not covered
by warranty.
4. Before connecting battery cables, make sure
terminals and posts are clean. Use a post cleaner
and wire brush to clean posts and terminals.
5. Connect cables to battery posts in numerical order
as labeled, RED TO POSITIVE & BLACK TO
NEGATIVE, use battery post covers and rubber
boots supplied (Figure 2).
NOTE: Apply a light coating of non-metallic grease or
protective spray on the cable connections to prevent
battery corrosion.
6. Check battery meter charge level. Machine must
be in full operation for correct reading (See
MACHINE OPERATION). Charge batteries if
necessary.
3
2
1
Tennant 5400 (02- -06)