Bosch GLM 100 C Consignes D'utilisation/De Sécurité page 10

Bluetooth
®
Do not use the measuring tool with Bluetooth ® in the vicinity of gas
stations, chemical plants, areas where there is danger of explosion
and areas subject to blasting. Do not use the measuring tool with
Bluetooth ® in airplanes. Do not use the measuring tool with
Bluetooth ® in the vicinity of medical devices. Avoid operation in the
direct vicinity of the human body over longer periods of time. When
using the measuring tool with Bluetooth ®, interference with other devices
and systems, airplanes and medical devices (e.g., cardiac pacemakers,
hearing aids) may occur.
The Bluetooth ® word mark and logos are registered trademarks owned
by Bluetooth SIG, Inc. and any use of such marks by Robert Bosch Tool
Corporation is under license.
FCC Caution
The manufacturer is not responsible for radio interference caused by
unauthorized modifications to this equipment. Such modifications could
void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received, including interference
that may cause undesired operation.
NOTE! This equipment has been tested and found to comply with the limits
for a Class B digital devices, pursuant to Part 15 of the FCC rules. These limits
are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• I ncrease the separation between the equipment and receiver.
-10-