Endress+Hauser eco-graph Mise En Service page 204

5.4 Subnet mask allocation
The subnet mask must be input if the device is to establish connections in another
sub-network. Specify the subnet mask of the sub-network in which the device is
located (e.g. 255.255.255.000). Please observe: the IP address determines the class
of the network. The result of this is a default subnet mask (e.g. 255.255.000.000 for a
Class B network).
5.5 Gateway allocation
Enter the IP address of the gateway here, if connections are to be established in
other networks.
As the unit does not, at the moment, set up a connection itself via the Ethernet, it is
not necessary to enter a Gateway. Leave the set-up at "0.0.0.0".
Note:
Changes to the system parameters are not activated until the SETUP menu is closed
and the settings accepted. Only then will the device work with the new settings.
6. Communication in the network via PC software
After the device has been configured and connected to the PC network, a connection
to one of the PCs in the network can be established.
The following steps are required for this:
1. Install the supplied PC software on the PC via which communication is to
take place.
2. A new device now has to be registered in the database.
After the device description has been input, select how the device settings
are to be transferred. In this case, select Ethernet (TCP/IP):
6