Key Automation TURBO 50 Instructions Et Avertissements Pour L'installation Et L'usage page 15

4.3 - Fixing
Take the lid off unscrewing the screws (fig.5). Put the gearmotor on
the plate. Insert the two socket head screws (fig.6).
It is important to lock the two socket head screws forcefully, making
sure, that the gearmotor is steady on the ground, during the whole
gate running.
4.4 - Rack assembling
Release the gearmotor as indicated by the fig.2 and open entirely
the gate.
Put a rack element on the pinion gear and fasten it to the gate with
screw and spacing bars.
Move the gate manually bringing the pinion gear into line with the
last spacing bar.
Fasten the rack element for good.
90mm
Fig. 5
Fig. 8
If the regulating allowed by the rack is not sufficient, it is possible to
counterbalance the gearmotor high working on the four screws
(fig.7).
The screws should be tightened again after the motor has been
operated a few times.
Fig. 6
For a correct positioning of the other elements and to assure their
straightness, it is necessary to employ a rack element using it as
support and reference (fig.9).
It is besides necessary to assure an aperture of 2 mm between
rack and pinion gear, so that the gate weight doesn't rest on the
gearmotor pinion gear (fig.8).
EN
Fig. 7
Fig. 9
15