Fig 1 - Wellis Igneus Manuel D'installation

Straight Style A-General guide:
EN
1. Place the bottom panel in the desired location (it's better in bath room near the
drainage) and assembling back panel. Make sure they are in line. At this point, someone
should be hold the rear panel until the next connection is made. SEE FIG 1 and 2.
2. Install the left and right side panels as below image FIG 3 and 4. Tighten the back
panels and sides panels with embedded latching system. See FIG 5.
3. Install roof panel bench and bench supporter. Slide the bench supporter between the
two vertical guides on the side panels. Install the bench top by placing it on top of the
bench stand and the horizontal guide on the rear panel. See FIG 7 and 8.
Secure the roof with the supplied screws (4x25mm) to the side panels. Otherwise, the
door cannot be properly adjusted. (Since the weight of the glass door pulls away the side
glass and raises the roof.) Place the sauna on a horizontal surface or set it in a horizontal
position

FIG 1

FIG 3 FIG 4
FIG 2
FIG 5