Usage Guide - Wellis Igneus Manuel D'installation

STOVE operation Installation
The stove with interior controller---rotary switches.
1, The left switch is timer to set working time of the stove. The right switch is temperature
setting switch to set temperature.
You should set time and temperature to your desired value at the same time, then the
stove starts to work, and the timer start to count down.
2, When timer comes back to 0, the stove will stop working.
3, If the timer doesn't come to 0, but the temperature reaches the setting value, the stove
also will stop working. But timer won't stop counting down.
When the temperature in sauna cabin is lower than the setting value, and timer doesn't
come to 0, the sauna will restart to work.
If the timer come to 0, you should turn the rotary switch of time to certain time, then the
stove will restart to work.
4, Please don't use the sauna too long time.

Usage Guide

Allow your sauna to warm up for 30 minutes at 120 F (43 C). You may close the vent on
the ceiling to speed up the preheating process.
Drink plenty of water to avoid dehydration before and after the sauna session. It is
recommended not to exceed 40 minutes per session.
If the sauna becomes stuffy, open the vent on the ceiling to allow fresh air into the sauna.
After 2 hours of continuous use, shut the sauna down for one hour.
To avoid burns, don't touch the heating elements.