Electrical Requirements; Package Information - Wellis Igneus Manuel D'installation

Installation Guide
EN
Please read the following directions carefully.
This type of sauna use embedded latch locking system fixed together, the installation
requires 2~3 persons. Put on gloves and pay more attention not to hurt yourself during the
installation.
To assure the installation smoothly and use well in future, please install each step
carefully and make sure placement and connection of each panel balanced and tightly.

Electrical Requirements

Each sauna will require an exclusive circuit when plugged in an outlet. A exclusive
circuit requires that no other appliance to share the outlet/circuit with the sauna. Failure
to comply with this requirement may cause electrical interruption and diminished
performance. (4.5KW stove we provide 40A leakage protector, 8KW and 9KW stove we
provide 63A leakage protector)
Please make sure the sauna is properly grounded. Serious injury may result if proper
electrical requirements are not met.
It is recommended that a qualified electrician install your dedicated electrical wiring for
proper sauna functionality and to avoid any potential electrical hazards, especially for the
big power saunas which requests to connect with an air switch on your side.

Package Information

Traditional saunas (with a front panel full glass) are packed in 6 cartons (Package 1 for
top and floor panel, benches and spare parts. Package 2 for back panel. Package 3 for
left and side panel. Package 4 for glass. The extra two package stove and stone)
Each sauna has a sole serial number which was shown on each package carton of sauna
cabin. Please make sure the cartons you get are with a same serial number, so that you
can assemble the unit well.
Please make sure that when you open the package cartons keep face up. Please be very
careful when opening boxes, due to fragile parts and glass.
Where to Start
Lay the cartons flat on the ground and open them carefully.
Open all the cartons, take the floor (bottom panel) from carton A firstly, start to install your
sauna pleasantly.
Tips: Before the start of installation, or at least before installation of the top panel, please
take out the accessories and screws etc.