Input Menu - Fracarro KSTT Instructions D'emploi

TS INPUT
Set the DiSEqC tone
Reading the frequency of the
local oscillator
IF frequency of the trasponder
to be received
Symbol rate of the trasponder
to be received
FEC of the trasponder to be
received
Management of
incoming channel
View the output
channel list, their
position in the priority
queue and allow to
delete one by one.
Clear the output
channel list
Confirm the settings by pressing the
There is the INPUT menù on detail:
LNB – To set the tone 0/22 KHz for band selection (High/Low) and the voltage 14/18 V to select the polarity.
DiSEqC – To set DiSEqC depending on the satellite (A, B, C o D).
FREQ.OL (MHz) – Read only value – it is visualized "AUTO".
FREQ.IF (MHz) – To set the IF frequency of the transponder to be received (it is necessary to know this value
before carry out the programming).
SYMBOL RATE – To set the symbol rate of the transponder which has to be received (it is necessary to know
this value before carry out the programming).
FEC – Read only value – it is visualized "AUTO".
UPDATE LIST IN – updates the incoming program list

8.5 INPUT MENU

Set Remote Power for LNB
LNB
DiSEqC
FREQ.OL (MHz)
FREQ.IF (MHz)
SYMBOL RATE
FEC
CHANNEL LIST IN
list
CHANNEL LIST
OUT
CLEAR LIST OUT
modules programmation.
OFF 18V/22KHz
satellite A
satellite B
A D
satellite C
satellite D
Read only
AUTO
950 2150
directly by the digit k eyboard
2000 40000
Read only
AUTO
ADD
REMOVE
CHANNEL FEATURES
PROG. NAME
USED BIT RATE
PROGRAMME TYPE
AVAILABLE BIT
ID SERVICE
Enter with
< ( ) Channel 1 > POSITION
REMOVE
LCN CONF.
LCN SET
< ( ) Channel 2 >
Refer to the same
programming menu of
Channel 1
< ( ) Channel N >
key; save the settings by pressing the S key after the
23
OFF
14V/0KHz
18V/0KHz
14V/22KHz
18V/22KHz
Increase/decrease by TPE
arrows or enter the value
Increase/decrease by TPE
arrows or enter the value
directly by the digit k eyboard
X/X
1/X
Selection of program
priority sended to the
COFDM modulator
Enable
Disable
Increase/decrease by
using TPE arrows
0 - 999 LCN
1000
0
1000
Disable
Insert value
directly from TPE
numeric keyboard.