Erie water treatment ProFlow PF-GAC1 Instructions D'installation & Emploi page 11

PROGRAMMING INSTRUCTIONS -
CONFIGURATION PARAMETERS

Before entering the programming mode, make sure that
the appliance is in the service mode.

All configuration parameters on this appliance have
been pre-programmed in the factory, to offer optimal
performance in a wide range of applications and situations.
Nevertheless it may be necessary or desirable to change any
of these parameters, to further optimize the appliances
performance or to adapt it to the specific requirements of
the installation.

In case no button is pressed in a period of 5 min, the
control panel will automatically return to the service mode;
any changes made will NOT be saved!
1. Press the scroll button and hold it for 6 sec until the
display shows:
System Check
2. Within 10 sec, press the up
show:
MaintInt: 24mths
•
Press the up or down
maintenance reminder function by setting the
maintenance interval, or deactivate the maintenance
reminder function.
3. Press the scroll button again; the display will show:
Cycle 1: XX min
•
Press the up or down
of the regeneration cycle.
•
Press the scroll button again to advance to the next
regeneration cycle.
Cycle 1 Backwash
Cycle 2 No function
Cycle 3 Fast rinse
Cycle 4 No function (PF-GAC1,5 & PF-AG1,5)
4. Press the scroll button again; the display will show:
Regen @
•
Press the up or down
regeneration.
5. Press the scroll button again; the display will show:
AUX2: Regen
•
Press the up or down
of auxilliary contact 2:
ELECTRONIC CONTROL PANEL
button; the display will
button to activate the
button to set the length
0:00
button to set the time of
button to set the function
Page 11
 Regen: aux. contact is powered during entire
regeneration.
 Maintenance: aux. contact is powered when
Maintenance Reminder is triggered.
 Error: aux. contact is powered when timer failure
occurs.
6. Press the scroll button again; the display will show:
Exit
•
Press the up or down
into the NOVRAM® and exit the programming mode.
button to save the settings
EN - English