Mirror Printing Function - Brother P-touch PT-9600 Manuel D'emploi

Ch. 3 Functions
To change the setting for the Block Length
function:
1 Hold down d and press 1 or 2.
NOTE
This step may be skipped if settings for several for-
mat functions are being applied at the same time.
2 Press j or k until B. LENGTH is dis-
played. The current setting is shown on the
left side of the display.
1 2 3 4 5 6 7 8 9
R
R
G
12/13
R
H
NO
R B. LENGTH
L
R
I
M
AUTO
R
J
AUTO 1.10
Length Margin
3 Press m or g until the desired setting is
displayed, or use the number keys to type in
the desired block length.
NOTE
☞
To return the function to its default setting
(AUTO), press the space bar.
☞
To change the setting in 0.1" (1.0 cm) steps,
hold down either m or g, and then release
the key when the desired setting is displayed.
☞
The block length is displayed in the currently
selected unit of measurement (inches or centi-
meters). The unit of measurement can be
changed with the Setup functions. (Refer to refer
to page 68.)
☞
To return to the text without changing the for-
e
matting, press
1 2
press or ).
4 Press n to apply the setting.
NOTE
To apply several format settings at the same time,
continue pressing j or k to select the function,
then pressing m or g to select the desired setting.
Press n only after the necessary functions have
been set.
32
K Q Q Q Q Q
A B C D E F
Q Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q
HELSINKI A AUTO
Font Width Size
d
(OR hold down and

Mirror Printing function

(d + p)
This function prints your label so that the text
can be read from the adhesive side of the tape. If
mirror-printed labels are attached to glass or
some other transparent material, they can be
read correctly from the opposite side.
NOTE
When using the Mirror Printing function, the text
should be printed on clear tape.
OFF
ON
When ON is selected, the Mirror Printing indi-
cator at the top of the display comes on.
1 2 3 4 5 6 7 8 9
R
R
G
<<< P-touch >>>
R
N O
H
R
L M
R
I
1:_
R
J
AUTO 1.10
Length Margin
To print a mirror image of the text:
1 Hold down d and press p.
1 2 3 4 5 6 7 8 9 A B C D E F K Q Q Q Q Q
R
R
G
R
N O
H
R MIRROR
L M
R
I
OFF
R
J
AUTO 1.10
Length Margin
2 Press m or g until the desired setting is
displayed.
NOTE
☞
To return the function to its default setting
(OFF), press the space bar.
☞
To return to the text without changing the for-
e
matting, press
p
press ).
3 Press n to apply the setting.
K Q Q Q Q Q
A B C D E F
Q Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q
HELSINKI A AUTO
Font Width Size
Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q Q
Q Q Q Q
HELSINKI A AUTO
Font Width Size
d
(OR hold down and